It contains constantly updating information about the active movie’s time.
· Time is a timecode in the format hours : minutes : seconds : sub-seconds. The sub-seconds counter can be set using Preferences….
— Click the word “Time:” to display the movie time remaining instead of the current movie time. The word “Time:” is then shown in italics (Time:) to indicate this. Click it again to display the current time.
· Length is the duration of the movie.
• Clicking in the zoom box reveals constantly updating information about the active movie (shown below).
 
· Frame is the number of the current frame being played.
— To cancel a frame count, press the escape key, or type command-.
(the command key and the period key).
— Click the word “Frame:” to display the number of frames remaining instead of the current frame. The word “Frame:” is then shown in italics (Frame:) to indicate this. Click it again to display the current frame.
· Total is the total number of frames in the movie.
· FPS is the number of frames that were actually played in the last second. A more accurate value is achieved if background applications (including control panels such as Launcher) are not open.
· Movie is the number of frames in the movie in the last second. This number may be greater than FPS because QuickTime may skip frames in order to keep up with the time. It can be thought of as the number of frames that should have been played in the last second for the movie to play at its best.
Tip: While editing movies, it is a good idea to keep the Realtime Palette closed or ‘zoomed in’. When the movie changes and the Realtime Palette is ‘zoomed out’, the number of frames has to be recalculated, and this may take a few seconds, depending on the movie’s length.
